Follow these simple steps to install your artwork safely and correctly.

Step 1: Unbox Carefully

Open the package and gently remove each part of the artwork. Lay them flat on a table and identify the three elements: the 4-bead line, the 3-bead line, and the connecting line.

Tip: Place a soft cloth on the table first to protect the glass beads from scratches or damage.

Step 2: Locate the Wall Brackets

Find the metal brackets inside the two wooden sleeves included in the box. Choose the spot on the wall where you want to hang the artwork.

Important: For the Large version, leave at least 6 feet of unobstructed space below the installation point. For the Medium version, 4.5 feet is recommended.

Refer to the diagram below for the maximum recommended spacing between the two bead lines. You can adjust the spacing to suit your wall and swap the position of each line to create the composition you prefer.

Step 3: Mark the Holes

Hold a bracket against the wall and mark the screw holes with a pencil.

Important: Make sure the hole in the metal pipe is facing upward (as shown in the image below). This is key for proper alignment.

Step 4: Drill and Insert Anchors

Drill holes at the marked points, then insert the provided wall anchors. Wipe away any dust or pencil marks.

Step 5: Mount the Brackets

Attach both metal brackets to the wall using the included screws. Make sure they are secure and level.

Step 6: Attach the Wooden Sleeves

Press each wooden sleeve firmly onto its wall bracket until it fits securely in place. Align it so the hole in the pipe is pointing upward.

Step 7: Secure and Straighten

Insert and tighten the top screw to connect the wooden sleeves to the brackets. Finally, straighten the ropes so the artwork hangs cleanly and evenly.

Tip: It’s best to have an extra set of hands to support the rope and the weight of the glass while you screw in the wooden sleeve. Once secured, wrap the rope neatly around the sleeve.

Step 8: Install the Connecting Line

Take the rope with two metal ends (included in the box). Straighten it so it unrolls smoothly without knots. Insert one end into the hole next to the pre-installed rope, pushing until it makes contact with the internal metal lock inside the wooden sleeve. Then wrap the rope around the sleeve to connect the two bead lines.

Note: We recommend gently smoothing the connecting line with your hands before installation to make it easier to handle.

Step 9: Arrange the Glass Beads

Once the artwork is securely installed, use the small Allen key from your accessories bag to adjust the position of each element. Spread the glass beads evenly to your liking.

Tip: To match the arrangement shown on our website, use the measurements indicated in the drawing below.

Replacing elements

Exchanging the wooden sleeve

Swapping glass beads